Can intex pools winterize

If possible, store at room temperature, and keep it away from any nesting mice, birds, or other critters that may chew holes through the vinyl. A large, clean, new trash can placed in the basement or garage may be an ideal location for winter storage. Allow the water to spill out slowly. If the pool floor has dirt or debris in it, use a pool brush or a soft push broom to sweep the bottom of any film or remaining dirt before draining.

Push a garden hose or vacuum hose straight into the pool water so that the entire hose fills up with water. Cap the other end of the hose with your thumb and quickly pull all of the hose over the wall except for the foot section.

Keeping the other end capped with your thumb and low to the ground, pull out the hose to a lower area for draining and release your thumb with the hose on the ground. As long as the pool end is higher than the discharge end, your siphon should start immediately. This method of siphon draining your pool can also be done with a pool vacuum hose. If you have a small sump pump, or a pool cover pump, these can be used to drain the Intex pool. Connect a garden hose, plug it in, and carefully place the pump in the bottom of the pool, near the edge.

You can rent a small pump at a rental shop, or we have a nice variety of cover pumps. You may have already realized that you could remove the hose from the pool filter and drain water right next to the pool. This will work, however, only down to the level of the return. This can be dangerous, not just to nearby plants or mulch beds, but to the pool, which can rip or develop holes during the process. The first step in winterizing Intex pool is to clean it.

If you ignore this step you may damage your filters or your pump, so take some time to clean the pool. Use a skimmer to collect anything from the surface, then vacuum the sides and the bottom. Water and the electricity mix brings no good things, so to avoid a potentially lethal incident, unplug and disconnect any power source around the pool. Take all the accessories — ladders, a skimmer, toys, floating tables, etc — out of the pool, clean them and let them dry before storing someplace dry.

Take the drain connector, and follow the instruction manual to attach the hose. This will get the water going. Now all you can do is wait and check from time to time if the connector is properly attached and the hose is in its place. As the water level drops, take a mild cleaner and a soft cloth to brush the pool walls. With all water out, remove the drain connector and the garden hose, and put the inside drain plug and the outside drain valve cap back in their place.

Using a soft cloth, warm water, and mild cleaner wipe the inside of your swimming pool, then rinse it and drain it again. It is important to remove any dirt or anything that can mess with your pool chemistry once you restart it. In your instruction manual should be described how to deconstruct the frame. Just follow the guide and, let the parts completely dry and store them somewhere dry. Otherwise, you would need a pool leaf cleaner.

Refer to the user manual of your pool to make sure you do it the right way. Additionally, you can drain some water through the pipes several times to avoid the struggle of cleaning them after winter. You can also add some cleaners in the water to clean the inner side of the valves and pipe for hygiene purposes. Make sure to rinse off the water by cleaning it with a soft piece of cloth. You can use various types of pool cleaners for the task. You can also remove the frame and keep the liner dry before putting it away.

It is a little tricky part as you need to completely soak the water from the liner to protect it from moisture. Consider sprinkling some cornstarch so that it can absorb every drop of water from it. You can also heat your pool with the sun to give it a final touch to settle down. If you want to reuse your liner after the season, then you must store it with proper care.

You can start folding the liner by one-sixth of it with double layers. Repeat the process from the opposite side as well. After that, you need to keep doing the above steps from the unfolded sides until you lay it flat. Now, all you need to do is create a square with your liner and prepare it to store. Everything stored away in a clean, dry place for that freezing cold winter coming?

And you have a nice, spacious yard again to boot. Closing your pool will be a lot easier as a result, but you should reserve at least part of two days to do it.

This will help you nail your chemical balance and keep the surprises to a minimum on pool opening day next spring. A note on maintenance: this winter, just be sure to check your chemical balance on those warmer days above 65 degrees Fahrenheit, or so , so you can discourage any kind algae that might want to start growing.

A thorough inspection now could save you tons of headache later. Be sure to vacuum the sides and bottom of your pool with a manual vacuum or an automatic cleaner like the Blue Torrent Stinger Automatic Pool Cleaner. This will help eliminate any microscopic bacteria that might be ready to grow once its undisturbed. No, thank you. Achieving pool closing chemical balance now will save you any nasty surprises when you open your pool again next year.

The short version? Your pH should be between 7. Getting the right levels keeps your pool healthy—and makes it less likely to generate some serious stress. Just be sure you shock at dusk or at night, or else the sun will render it ineffective.

Check out your manual to confirm which applies to you. Time to turn off your circulation system, including your pump and filter. Go ahead and disconnect them from their power source, and remove the hoses that attach them to the pool itself. Then store them indoors in a dry, protected place. Here it is, the last step. Now you just need to cover your pool with a winter pool cover. Take precautions to avoid accidents, okay?